Current Address:

BYO Modem Router Set up (FTTN)

Please note, while we are BYO router-friendly, Skymesh Support Agents are not trained to configure or support third-party equipment, you may need to contact your router manufacturer directly.

Here are some key steps for setting up your BYO router:

1. Please be sure to connect the phone cable from your phone port to the DSL port on your router.

### Please DO NOT place cable in the LAN port ###

2. Connect your device (PC or laptop) to the router via LAN 1 (preferred) or to your router’s Wifi network.
Your router’s default Wifi Network Name and Password will be labeled on the back or bottom of your router.

4. To log into your router please open a web browser on your device (Chrome, Firefox, Microsoft Edge, Safari etc).
Enter the Default Access/Gateway web address labeled back or bottom of your router.

*** Examples of Default Access/Gateway addresses found on various routers ***
Asus: 192.168.1.1
D-Link: 192.168.0.1 or http://dlinkrouter.local or 192.168.1.1
Huawei: 192.168.1.1
Netcomm: 192.168.20.1
Netgear: 192.168.1.1 or 192.168.0.1 or http://www.routerlogin.com
Sagemcom F@st: 192.168.0.1 or 192.168.1.1 or 10.1.1.1
Technicolor: 192.168.1.254
TP-Link: 192.168.1.1 or http://tplinkwifi.net or http://tplinkmodem.net

5. At the router login page, please enter the username and password listed back or bottom of your router. Please be aware some routers will have a different process, so please complete the required steps to successfully log in to your router.

6. To begin, please click Settings/Internet or Quick Setup/Setup Wizard.

NOTE: All routers are different if you need help consult your router manual – searching for, VDSL, Dynamic IP or IPOE, or DHCP or Obtain IP Address Automatically to help guide you.

7. Set your Internet Service type as VDSL and the connection type to  Dynamic or IPOE or DHCP or Obtain IP Address Automatically (depending on the router preference), No VLAN ID and do not clone MAC address and save your settings. Please note your internet connection does NOT require a Username and Password to be configured in your router setup.

Tips: If your router requires an Operation Mode please choose Modem Router mode. You can usually find this on the quick setup page, or by clicking the Advanced tab and selecting Operation Mode from the menu on the left of the page.

8. Your router will now save your settings and reboot.

9. Test your internet connection by browsing a website.

### Alternatively you can test if your internet connection is active by connecting the ethernet/network cable coming from the NBN UNI-D port directly into your PC or Laptop and attempting to browse the internet after 1 minute. ###

Please note that Telstra routers must be Factory Reset before successfully connecting to the Skymesh Network.

Perform a Factory Reset by leaving your router powered on. Use a paperclip or something sharp press the reset button on the bottom of the unit and hold it for 10-15 seconds then release.

Allow your router 2-3 minutes to reboot after a factory reset.

If issues persist consult your router manual or contact your router supplier for help.

Asus: 1300 278 788
Netgear: 1300 361 254
D-Link: 1300 766 868
TP-Link: 1300 875 465
Asus: 1300 278 788

Check your address

See what’s available at your property
    Close

    Check your address

    See what’s available at your property